Auto Mate 5104A Manual de instrucciones descargar pdf (Pagina 24)

Valet Mode

Valet mode can be entered and exited by using the vehicle key and

the control button. When entered, the alarm functions are defeated

while the convenience features still operate normally.

Arm and Disarm commands lock and unlock the doors. The remote

control emits the Arm in Valet and Disarm in Valet output as described

for Arm and Disarm in the Basic Commands section.

Use the following steps to manually enter and exit Valet Mode:

1. Turn the ignition switch On and then Off

2. Immediately press and release the control button once

3. The control center LED turns On when entering and Off when

exiting.

Power Save

To reduce power consumption the control center status LED modiﬁes

its output if the vehicle is parked for an extended period. If Armed the

ﬂashing is reduced after 24 hours. When Valet mode is On the LED

will turn off after 1 hour and will reset each time the ignition is turned

off.

Rapid Resume

If power is ever disconnected by a mechanic or thief, the system will

resume the state it was in at the time of disconnection, when power

is reconnected.

No Remote Output

Occasionally when a command is performed the remote may not

generate a command conﬁrmation output or Out of Range output.

This indicates that the system received the command but it was an

incomplete command (e.g. Aux button pressed too short to activate

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 36 37

Sin comentarios

Auto Mate 5104A Manual de instrucciones Pagina 24