18
© 2012 Directed. All rights reserved.
Manual Transmission Start (MTS mode)
When installed into a manual transmission vehicle, the system requires
that the MTS mode is properly set when parking. If MTS mode is not
properly set or is defeated after being properly set the system will not
start the engine.
1. With the engine running, press the foot brake and set the park-
ing brake. For Pit Stop or Turbo Timer mode (to leave the engine
running after arming), open the driver door.
2. Release the foot brake.
3. Within 20 seconds of foot brake release, press any command
button on the remote, after 20 seconds return to Step 2 (For Turbo
Timer Mode, press the optional dash mounted activation button) .
4. The parking lights flash 5 times to confirm MTS mode enable and
the remote start activates the ignition outputs.
5. Turn Off and remove the key from the ignition switch, the engine
remains running.
6. Exit the vehicle, close all the doors and arm the system.
7. The engine turns off and after a few seconds. If the door is
opened in Step 3 then the engine continues to run.
Turbo Timer Mode
The system keeps the engine running for the Turbo Timer runtime and
can only be activated by an optional dash mounted activation button.
1. With the engine running, set the parking brake (see previous
information for manual transmission vehicles).
2. Press the optional dash mounted activation button.
3. The parking lights turn on and the remote start activates the igni-
tion outputs.
4. Turn Off and remove the key from the ignition switch, the engine
remains running.
Comentarios a estos manuales